THIS IS NOT ASSEMBLED!!!



INCLUDES:

1x 12vdc Relay

1x 5vdc Relay

1x 10K Ohm Resistor

1x Momentary Normally Open Push Button Switch

1x Circuit Board

1x Case

1x 1000uF Electrolytic Capacitor

1x Jumper Wire (not visible in picture)

1x Mono Jack

1x Mono Plug

1x 6 foot USB Cable (not visible in picture)



NOT INCLUDED

Cable for Remotely Mounted Power Switch

Cable for Module to Laptop connection

Cable for Module to Power connection



PLEASE READ THE SITE'S CONDITIONS OF USE BEFORE PURCHASING THIS MODULE. IT IS REQUIRED TO PURCHASE THIS ITEM.



The instructions are included in the conditions, and they are included with your order.



As recommended by most users of this module, a great software addition to this module is the ShutControl - ShutDown Control program for Laptops. Last updated April 25, 2007

For more information or to download the program, please visit -=[ HERE ]=-



Check out this page for more information on the module. HERE



Since we've been asked quite a bit, yes, this can be used to turn on a LCD monitor if it uses a momentary switch. This module replicates a momentary switch, so it can be used for anything that uses a momentary switch to turn the device on. LCD monitors, laptops, desktops, docking stations, external hard drives, etc. BUT if you aren't using this for a laptop/pc you might want to purchase the Auto-On Module (non pc usage) as it's a little cheaper and will do the job just fine.



Mounting Hole For Jack: The mounting hole should be .27 inches.. so a 1/4 inch bit and twisted a very slight bit should be perfect.

Mounting Hole For Switch: The mounting hold should be .25 inches.. so a 1/4 bit should be perfect.